checkered steel plate, also known as reticulated steel plate, is a steel plate with convex (or concave) pattern on the surface.The pattern on its surface can be a single diamond shape, lentil shape or round bean shape, or two or more patterns can be properly combined to form a combined pattern plate.The pattern is mainly used for anti-skid and decoration.The combined pattern board has better anti-skid ability, bending resistance, metal saving and appearance than the single pattern board.

Types:

Galvanized Steel Checker Plate:

Galvanized checker plate refers normally to hot dipped galvanized steel plate with zinc coating layer. The galvanizing on the steel sheet surface will help avoid rusting when the checkered steel plate is exposed to moisture environment. The zinc coating amount will meet Chinese or international standard requirements. With a certain degree of slip resistance, good corrosion resistance, beautiful appearance and economic cost, galvanized steel checker plate is widely used in elevator decorative plate, shops decoration, engineering, exterior design of the building, etc

Checkered Carbon Steel Plate:

This is the base metals for galvanized checker plate, seldom supplied without further coating. It costs less compared with other checkered steel, yet easily get rusty.

Stainless Steel Checkered Plate Coils or Cut to Size: 300 Series as most popular materials.

General Technical Introduction:

Major stainless steel sheet material: SS 300 series, 200 series and 400 series. 200 series: 201,202.

300 series: 301,304,304H,304N,304L,304LN,309S, 310S,316,316Ti,316L,316N,316LN,317,

317L,321,321H,347,347H.

400 series: 405,409,403, 430,410,420, 440c.

Thin gauge 2mm to 6mm; thick gauge 6.00mm to 12.70mm.

Stainless steel has good mechanical properties with including excellent corrosion resistance, heat resistance.

Standard followed: ASTM,AISI,GB,JIS,SUS,EN,DIN and etc.

Hot rolled or cold rolled steel.

Substrate requirements

According to different substrate materials, checkered steel plate products can be divided into four series:

Carbon structural steel: GB/T 700 medium grades such as Q195, Q215, Q235, etc.;

low-alloy high-strength steel: GB/T 1591 in the number such as Q345;

structural steel for hull: GB 712 A, B, D, E and other steel grades;

High weathering structural steel: The grades in GB/T 4171 are Q295GNH, Q235NH, etc.

Note: If the grade of the checkered steel plate is "H-", the chemical composition will be the corresponding standard for the substrate. For example, the chemical composition of H-Q235B is the same as that of Q235B. If it is a brand without H, the detailed regulations need to refer to the corresponding standard.

Application of checkered steel plate

1.The common pattern board is widely used in shipbuilding, boiler, automobile, tractor, train carriage and construction industry.

2.The steel plates with protruding edges on the surface are used for floors, factory escalators, working frame pedals, ship decks and automobile floors.

3.The steel plate with diamond or lentil pattern on the surface is used for the pedals of workshops, large equipment or ship aisles and stairs.

Basic thickness of checkered steel plate

The specification of checkered steel plate is expressed by basic thickness (excluding the thickness of protruding edge), and there are 10 specifications of 2.5-8 mm.No.1-3 steel plate is used for pattern plate.

The welding seam on the upper surface of the pattern plate should be polished smooth before anti-corrosion operation.In order to prevent weld fracture or arch deformation of steel plate caused by thermal expansion and cold contraction of plate, 2mm expansion joint shall be reserved at the splicing of each steel plate.The lower part of the steel plate shall be provided with a rain hole with a diameter of 10 mm and a distance of 1 m.